User Tools
qcl:simulation_output
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
qcl:simulation_output [2022/09/20 17:04] thomas.grange [Initial electronic states] |
qcl:simulation_output [2022/09/20 17:10] (current) thomas.grange |
||
|---|---|---|---|
| Line 101: | Line 101: | ||
| * ''Oscillator_Strength.mat'' gives the oscillator strengths. | * ''Oscillator_Strength.mat'' gives the oscillator strengths. | ||
| - | == Oscillator strength == | + | === Oscillator strength === |
| The oscillator strength is calculated from the formula | The oscillator strength is calculated from the formula | ||
| $$ | $$ | ||
| Line 108: | Line 108: | ||
| Note that the electron mass $m_0$ entering the above formula is the bare electron mass. | Note that the electron mass $m_0$ entering the above formula is the bare electron mass. | ||
| - | This oscillator strength (which is sometimes referred as the unnormalized one), differs from the usual definition in the single band case by the ratio $m^*/m_0$ | + | This oscillator strength (which is sometimes referred as the unnormalized one), differs from the usual definition in the single band case by the ratio $m^*/m_0$, i.e. $\frac{m^*}{m_0} f_{\alpha \beta}$ is called the normalized oscillator strength. |
| - | In the parabolic single-band case, the sum-rule is retrieved by dividing the | + | The advantage of this unnormalized definition is that it is general enough to be applied to the multiband case. |
| + | |||
| + | Note that in the parabolic single-band case, the usual sum-rule is retrieved by using the normalized definition | ||
| $$ | $$ | ||
| - | \sum_{beta \neq \alpha} \frac{m^*}[m_0} f_{\alpha \beta} | + | \sum_{\beta \neq \alpha} \frac{m^*}{m_0} f_{\alpha \beta} = 1 |
| $$ | $$ | ||
qcl/simulation_output.1663693497.txt.gz · Last modified: 2022/09/20 17:04 by thomas.grange
